the yellow led should go on and the device should enumerate as USBasp (see above)Ĭonnect the following two points on the board:.plug in the uDMX (with pin D5 still tied to ground).short pin D5 (the leftmost pin on the bottom line of the Atmega8) to ground (the black wire of the USB cable).In that case, it might be possible to still force the uDMX into the bootloader: In some cases the firmware is broken beyond repair and the udmx doesn’t enumerate, so we cannot issue a software command to start the bootloader. The terminal should answer:–> Started bootloader on device “uDMX” (-5)Īnd if you refresh the System Profiler Window (Cmd-R) you should see the USBasp instead of the uDMX:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |